Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.1.1. Mechanical part of engines
2.1.1.1. Cover of a head of the block of cylinders
2.1.1.2. Head of the block of cylinders
2.1.1.3. Laying of a head of the block of cylinders
2.1.1.4. Block of cylinders
2.1.1.5. Cranked shaft and radical bearing
2.1.1.6. Balancing block
2.1.1.7. Principle of operation of the balancing block
2.1.1.8. Damper of krutilny fluctuations of a cranked shaft
2.1.1.9. Forward cover of the engine
2.1.1.10. Piston
2.1.1.11. Piston rings and piston finger
2.1.1.12. Rod and shatunny bearing
2.1.1.13. The Klapanny mechanism – general information
2.1.1.14. Camshaft
2.1.1.15. Camshaft asterisk
2.1.1.16. Asterisk of a cranked shaft
2.1.1.17. Chain of a drive of the mechanism of a gazoraspredeleniye
2.1.1.18. Natyazhitel of a chain of a drive of the mechanism of a gazoraspredeleniye
2.1.1.19. The valve, a klapanny spring, the maslootrazhatelny cap, the directing plug of the valve
2.1.1.20. Valve pusher
2.1.2. Mechanism of change of phases of a gazoraspredeleniye
2.1.3. Greasing system
2.1.4. Cooling system
2.1.5. Fuel system
2.1.6. System of production of the fulfilled gases and system of decrease in toxicity
2.1.7. Electric equipment of engines
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-1-1-8-dempfer-krutilnykh-kolebanijj-kolenchatogo-vala.html

2.1.1.8. Damper of krutilny fluctuations of a cranked shaft
Fig. 2.14. Damper of krutilny fluctuations of a cranked shaft: 1–vertical projection; 2–section; 3–cogwheel of a pulley of a cranked shaft; 4–adjusting opening of a pulley; 5–damper of krutilny fluctuations

The damper of krutilny fluctuations preventing fluctuations of a cranked shaft, is integrated in a gear pulley of a cranked shaft. A groove of an adjusting shponka which is usually used for pulley installation on a cranked shaft, no. To level a pulley of a cranked shaft on cranked to a shaft, it is necessary to use adjusting openings on a forward cover of the engine and a pulley of a cranked shaft. The anchor bolt of a pulley of a cranked shaft has the inhaling moment in a plasticity zone, the inhaling is carried out in two steps. It provides stability of an axis of a bolt at an inhaling (fig. 2.14).
«previous page
2.1.1.7. Principle of operation of the balancing block		 following page»
2.1.1.9. Forward cover of the engine