Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.1.1. Mechanical part of engines
2.1.1.1. Cover of a head of the block of cylinders
2.1.1.2. Head of the block of cylinders
2.1.1.3. Laying of a head of the block of cylinders
2.1.1.4. Block of cylinders
2.1.1.5. Cranked shaft and radical bearing
2.1.1.6. Balancing block
2.1.1.7. Principle of operation of the balancing block
2.1.1.8. Damper of krutilny fluctuations of a cranked shaft
2.1.1.9. Forward cover of the engine
2.1.1.10. Piston
2.1.1.11. Piston rings and piston finger
2.1.1.12. Rod and shatunny bearing
2.1.1.13. The Klapanny mechanism – general information
2.1.1.14. Camshaft
2.1.1.15. Camshaft asterisk
2.1.1.16. Asterisk of a cranked shaft
2.1.1.17. Chain of a drive of the mechanism of a gazoraspredeleniye
2.1.1.18. Natyazhitel of a chain of a drive of the mechanism of a gazoraspredeleniye
2.1.1.19. The valve, a klapanny spring, the maslootrazhatelny cap, the directing plug of the valve
2.1.1.20. Valve pusher
2.1.2. Mechanism of change of phases of a gazoraspredeleniye
2.1.3. Greasing system
2.1.4. Cooling system
2.1.5. Fuel system
2.1.6. System of production of the fulfilled gases and system of decrease in toxicity
2.1.7. Electric equipment of engines
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-1-1-20-tolkatel-klapana.html

2.1.1.20. Valve pusher
Fig. 2.28. Scheme of operation of the klapanny mechanism: 1–valve pusher; 2–cam-shaft; 3–section of a pusher of the valve; 4–contact surface of a contour of a cam; 5–contact surface of a rod of the valve; 6–provision of marking

The design of a pusher of the valve has no adjusting washers. Besides the valve pusher, a rubbing surface of a cam фосфатируется for smoothing of a surface and increase of resistance to an istiraniye. To adjust a klapanny gap, it is necessary to replace a valve pusher. There are 35 standard sizes of pushers of the valve depending on thickness. For distinction of pushers they have the engraved marking (3 figures) (fig. 2.28).

Table 2.11 of the Characteristic of a pusher of the valve
«previous page
2.1.1.19. The valve, a klapanny spring, the maslootrazhatelny cap, the directing plug of the valve		 following page»
2.1.2. Mechanism of change of phases of a gazoraspredeleniye