2.2.10.9. Installation of a fixing bolt of a pulley of a cranked shaft

Fig. 2.86. Installation of the special adaptation on a cam-shaft

Establish the special adaptation on a cam-shaft (see fig. 2.86).

Fig. 2.113. Lock bolt of a pulley of a cranked shaft: 1–bolt

Establish a lock bolt of M6x1,0 and tighten it a hand (fig. 2.113).

Turn a cranked shaft clockwise to VMT of the piston of the cylinder No. 1.

Fig. 2.104. Installation of the special adaptation on a cranked shaft: 1–special adaptation

Hold a pulley of a cranked shaft the special adaptation (see fig. 2.104).

Tighten a fixing bolt of a pulley of a cranked shaft in two steps:

tighten a bolt the moment of 96-104 N · m;

tighten a bolt on 87-93 °

Unscrew M6x1,0 bolt.

Remove the special adaptation from a cam-shaft.

Take out the special adaptation from an opening of the bottom cap of the block of cylinders.

Turn a cranked shaft clockwise on two turns to VMT of the piston of the cylinder No. 1. If it is not possible to reach situation VMT, weaken a fixing bolt of a pulley of a cranked shaft and repeat the described actions at first.

Establish the bottom cap of the block of cylinders and tighten it the moment of an inhaling of 18-22 N · m.