Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents WITH / SN in the fulfilled gases
2.2.3. Compression measurement in engine cylinders
2.2.4. Check of a belt of a drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Hermetic removal
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.10. Chain of a drive of the mechanism of a gazoraspredeleniye
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the zolotnikovy valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of a drive of the mechanism of a gazoraspredeleniye
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-2-1-dvigateli-modelejj-l8-i-lf.html

2.2.1. Engines of the L8 and LF models

As the power plant in Mazda 6 cars the 4th cylinder engines in which cylinders are located in one row are used. From below the engine is closed by the pallet forming a case which at the same time is the tank for the oil necessary for greasing, cooling and protection of details of the engine from wear.
All three engines 16-klapanny, having on four valves on one cylinder. Valves are put in action by two camshafts located above through tarelchaty pushers.
In this section procedures of check and repair operations without removal of the engine from the car are described, then, in detail considered a removal and installation order, and also repair of the details placed in the block and a head of the block of cylinders is described.
«previous page
2.2. Mechanical part of engines		 following page»
2.2.2. Verification of the contents WITH / SN in the fulfilled gases