Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents WITH / SN in the fulfilled gases
2.2.3. Compression measurement in engine cylinders
2.2.4. Check of a belt of a drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Hermetic removal
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.10. Chain of a drive of the mechanism of a gazoraspredeleniye
2.2.10.1. Preliminary operations
2.2.10.2. Removal of a fixing bolt of a pulley of a cranked shaft
2.2.10.3. Removal of a natyazhitel of a chain
2.2.10.4. Removal of a chain of a drive of GRM
2.2.10.5. Installation of a chain of a drive of GRM
2.2.10.6. Installation of a forward cover of the engine
2.2.10.7. Installation of a forward epiploon of a cranked shaft
2.2.10.8. Installation of a rubber support of the engine No. 3 and arm of fastening of the engine No. 3
2.2.10.9. Installation of a fixing bolt of a pulley of a cranked shaft
2.2.10.10. Installation of a cover of a head of the block of cylinders
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the zolotnikovy valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of a drive of the mechanism of a gazoraspredeleniye
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-2-10-2-snyatie-krepezhnogo-bolta-shkiva-kolenchatogo-vala.html

2.2.10.2. Removal of a fixing bolt of a pulley of a cranked shaft

Remove the bottom cap of the block of cylinders.
Fig. 2.103. Installation of the special adaptation

Establish the special adaptation (fig. 2.103).
Turn a cranked shaft clockwise to VMT of the piston of the cylinder No. 1.
Fig. 2.104. Installation of the special adaptation on a cranked shaft: 1–special adaptation

Hold a cranked shaft the special adaptation (fig. 2.104).
«previous page
2.2.10.1. Preliminary operations		 following page»
2.2.10.3. Removal of a natyazhitel of a chain