Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents WITH / SN in the fulfilled gases
2.2.3. Compression measurement in engine cylinders
2.2.4. Check of a belt of a drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Hermetic removal
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.10. Chain of a drive of the mechanism of a gazoraspredeleniye
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the zolotnikovy valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.18. Assembly of a head of the block of cylinders
2.2.18.1. Installation of a maslootrazhatelny cap
2.2.18.2. Installation of a head of the block of cylinders
2.2.18.3. Installation of cam-shafts
2.2.19. Assembly of a drive of the mechanism of a gazoraspredeleniye
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-2-18-1-ustanovka-maslootrazhatelnogo-kolpachka.html

2.2.18.1. Installation of a maslootrazhatelny cap

Napressuyte a maslootrazhatelny kopachok on directing plug of the valve manually.
Fig. 2.184. Installation of a maslootrazhatelny cap

Slightly допрессуйте the special adaptation, using a kapron hammer (fig. 2.184).
Establish valves, springs of valves and the top plates of springs of valves.
Fig. 2.185. Installation of crackers of valves

Establish valve crackers, using special adaptations (fig. 2.185).
Establish elevating eyes of the engine.
Establish new laying of a head of the block of cylinders.
«previous page
2.2.18. Assembly of a head of the block of cylinders		 following page»
2.2.18.2. Installation of a head of the block of cylinders