Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents WITH / SN in the fulfilled gases
2.2.3. Compression measurement in engine cylinders
2.2.4. Check of a belt of a drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Hermetic removal
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.10. Chain of a drive of the mechanism of a gazoraspredeleniye
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the zolotnikovy valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.16.1. Installation of covers of radical bearings
2.2.16.2. Installation of piston rings
2.2.16.3. Piston assembly
2.2.16.4. Installation of the shatunny bearing and cover
2.2.16.5. Assembly of the balancing block (L3 c mechanism of change of phases of a gazoraspredeleniye)
2.2.17. Assembly of the block of cylinders (termination)
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of a drive of the mechanism of a gazoraspredeleniye
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-2-16-4-ustanovka-shatunnogo-podshipnika-i-kryshki.html

2.2.16.4. Installation of the shatunny bearing and cover
Fig. 2.176. Installation of the shatunny loose leaf

Establish shatunny loose leaves in a head and a rod cover, as is shown in drawing 2.176.

ATTENTION
At assembly and installation of a cover of a rod, level a rod and a rod cover in the area of a break.

Tighten shatunny bolts in two steps.
Inhaling moment:
- the first reception – 26–32 N · m;
- the second reception – 80–100 °.
«previous page
2.2.16.3. Piston assembly		 following page»
2.2.16.5. Assembly of the balancing block (L3 c mechanism of change of phases of a gazoraspredeleniye)