Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.1.1. A car design with a body "sedan"
8.1.2. A car design with a body "hatch-back"
8.1.3. Body framework
8.1.4. Hinged and decorative components of a body
8.1.5. Doors
8.1.6. Window regulators
8.1.7. Dismantling and trunk lid assembly
8.1.8. Removal and installation of a front bumper
8.1.9. Dismantling and assembly of a front bumper
8.1.10. Removal and installation of a rear bumper
8.1.11. Removal and installation of a back slip
8.1.12. Removal and installation of a back spoiler
8.1.13. External rear-view mirrors
8.1.14. Removal and installation of an external mirror with the electric drive
8.1.15. Dismantling and assembly of an external mirror with the electric drive
8.1.16. Heater of back glass
8.1.17. The hatch on a roof
8.1.18. Seat belts
8.1.18.1. Removal and installation of a forward seat belt
8.1.18.2. Removal and installation of a back lateral seat belt
8.1.18.3. Removal and installation of a back central seat belt
8.1.18.4. Removal and installation of a forward buckle
8.1.18.5. Removal and installation of a back buckle
8.1.18.6. Seat belt check
8.1.19. Seats
8.2. Conditioner and heater
 







8-1-18-1-snyatie-i-ustanovka-perednego-remnya-bezopasnosti.html

8.1.18.1. Removal and installation of a forward seat belt

ATTENTION
Maloperation with a seat belt of forward sitting (with a prednatyazhitel) can lead a seat belt to casual operation of a prednatyazhitel to an iseryezny trauma.
The sensor of a lateral safety cushion is attached to the lower part of the central rack.
At work in the field of the central rack disconnect a negative wire from the storage battery or work accurately, avoiding excessive blows on the lower part of the central rack.
Do not assort a natyazhitel of a seat belt.
The spring of a natyazhitel which is unwound at removal of its cover, cannot be reeled up manually. In this case the natyazhitel will not work properly.


Turn the ignition switch in the situation LOCK.
Disconnect a negative wire from the storage battery and wait not less than 1 minute.
Remove the bottom overlay of the central rack.

Fig. 8.62. Detachment of a plate of the limiter of the socket of a seat belt


Using a screw-driver, raise a plate of the limiter of the socket of a seat belt with a prednatyazhitel (fig. 8.62).
Disconnect the seat belt socket with a prednatyazhitel.
Uncover.

Fig. 8.63. Seat belt removal


Turn off bolts and the screw, then remove a seat belt of a forward seat (fig. 8.63).
Establish as it should be, the return to removal.
Be convinced of that the lamp of the alarm system of system of safety cushions lights up approximately on 6 with, and then dies away.
If the lamp of the alarm system of system of safety cushions does not work, as is described above, in system there is a malfunction. Check system, using function of onboard diagnostics.

«previous page
8.1.18. Seat belts
following page»
8.1.18.2. Removal and installation of a back lateral seat belt