Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.1.1. A car design with a body "sedan"
8.1.2. A car design with a body "hatch-back"
8.1.3. Body framework
8.1.4. Hinged and decorative components of a body
8.1.5. Doors
8.1.6. Window regulators
8.1.7. Dismantling and trunk lid assembly
8.1.8. Removal and installation of a front bumper
8.1.9. Dismantling and assembly of a front bumper
8.1.10. Removal and installation of a rear bumper
8.1.11. Removal and installation of a back slip
8.1.12. Removal and installation of a back spoiler
8.1.13. External rear-view mirrors
8.1.14. Removal and installation of an external mirror with the electric drive
8.1.15. Dismantling and assembly of an external mirror with the electric drive
8.1.16. Heater of back glass
8.1.17. The hatch on a roof
8.1.18. Seat belts
8.1.19. Seats
8.2. Conditioner and heater
 






8-1-7-razborka-i-sborka-kryshki-bagazhnika.html

8.1.7. Dismantling and trunk lid assembly

Disconnect a negative wire of the storage battery.
Remove an overlay of a trunk lid.
To remove the external handle of a trunk lid and the cylinder of the lock of a trunk lid, remove a back slip.

Trunk lid components
Fig. 8.38. Trunk lid components: 1–clamp of a trunk lid and executive mechanism of the lock; 2–external handle of a trunk lid; 3–cylinder of the lock of a trunk lid; 4–clip; 5–limiter; 6–trunk lid sealant; 7–trunk lid


Disassemble in an order shown in drawing 8.38.
Gather as it should be, the return to dismantling.

«previous page
8.1.6.5. Removal and installation of the electric motor of a window regulator with the servo-driver
following page»
8.1.8. Removal and installation of a front bumper