Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of brake system
6.2.2. Check of level of brake liquid in a tank of a hydraulic actuator of working brake system
6.2.3. Brake hoses
6.2.4. Air removal from brake system
6.2.5. Check of the return valve of a vacuum hose (amplifier of brakes)
6.2.6. Check of a pedal of a brake
6.2.7. Removal and installation of a pedal of a brake
6.2.8. Removal and installation of the main brake cylinder
6.2.9. Check of the sensor of level of liquid
6.2.10. Dismantling and assembly of the main cylinder
6.2.11. Removal and installation of a forward brake disk
6.2.12. Replacement of forward brake shoes
6.2.12.1. Visual check of thickness of blocks
6.2.12.2. Removal of brake shoes
6.2.13. Check of lay brake system
6.2.14. Removal, check and installation of the back sensor of speed of a wheel of ABS
7. Onboard electric equipment
8. Body
 






6-2-12-zamena-perednikh-tormoznykh-kolodok.html

6.2.12. Replacement of forward brake shoes




When the case of the cylinder is open, do not press a brake pedal, the piston differently will jump out. Do not damage a boot of the piston and do not allow oil hit on a brake disk. Blocks always replace together with laying. If on laying there are traces of a rust or an otslaivaniye of a rubber covering, replace them new. A connecting bolt turn off only when dismantling and support replacement assembled. In these cases suspend the cylinder case on a wire so that not to stretch a brake hose. See off to extra earnings of frictional surfaces of brakes in case of boring or replacement of drums or disks, after replacement of brake shoes or frictional slips, and also if after small run the pedal starts to "fail".

Forward brake shoes
Fig. 6.38. Forward brake shoes: 1–brake shoes; 2–coupling springs; 3–tightening plates




«previous page
6.2.11.1. Check of a brake disk and components of the brake mechanism
following page»
6.2.12.1. Visual check of thickness of blocks