Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of brake system
6.2.2. Check of level of brake liquid in a tank of a hydraulic actuator of working brake system
6.2.3. Brake hoses
6.2.4. Air removal from brake system
6.2.5. Check of the return valve of a vacuum hose (amplifier of brakes)
6.2.6. Check of a pedal of a brake
6.2.7. Removal and installation of a pedal of a brake
6.2.8. Removal and installation of the main brake cylinder
6.2.9. Check of the sensor of level of liquid
6.2.10. Dismantling and assembly of the main cylinder
6.2.11. Removal and installation of a forward brake disk
6.2.11.1. Check of a brake disk and components of the brake mechanism
6.2.12. Replacement of forward brake shoes
6.2.13. Check of lay brake system
6.2.14. Removal, check and installation of the back sensor of speed of a wheel of ABS
7. Onboard electric equipment
8. Body
 






6-2-11-1-proverka-tormoznogo-diska-i-komponentov-tormoznogo-mekhanizma.html

6.2.11.1. Check of a brake disk and components of the brake mechanism

Check, whether there is no corrosion, wear and damage on internal walls of the cylinder. If necessary replace the cylinder case. The insignificant defects caused by corrosion or extraneous particles, eliminate with polishing of a surface by a small nazhdachny skin. Check, whether there is no corrosion, wear and damage on the piston surface, a directing finger, a boot of a directing finger and a surface of a brake disk. If necessary replace the corresponding component.

Fig. 6.35. Drawing of labels on a bolt of a nave and a brake disk


Mark a bolt of a nave of a wheel and a brake disk before removal for the subsequent installation (fig. 6.35).
Turn off a bolt of fastening and remove a brake hose.
Uncover a directing pin and a pin.

Fig. 6.36. Measurement of thickness of a brake disk


By means of a micrometer measure thickness of a brake disk (fig. 6.36).
Standard thickness: 26 mm.
Minimum thickness: 24 mm.
Replace a disk, if thickness of a disk less minimum admissible.
Fix a brake disk on a wheel nave wheel nuts (in two places or more).

Fig. 6.37. Check of palpation of a disk by means of the indicator


Check palpation by the indicator (fig. 6.37).
Measurement point:
at distance of 10 mm from an external edge of a disk.
Maximum palpation: 0,05 mm or less.

ATTENTION
Before carrying out measurement be convinced that axial люфт it is equal 0 mm.

If palpation considerable, find a point of the minimum palpation, consistently displacing the provision of installation of a brake disk on a nave on one opening.
Remove a rust or dirt from a surface of contact of a brake disk and a wheel nave.
Establish a brake disk and level the labels made before removal.

«previous page
6.2.11. Removal and installation of a forward brake disk
following page»
6.2.12. Replacement of forward brake shoes