Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.2.1. Engines of the L8 and LF models
2.2.2. Verification of the contents WITH / SN in the fulfilled gases
2.2.3. Compression measurement in engine cylinders
2.2.4. Check of a belt of a drive of auxiliary units
2.2.5. General information and safety measures at removal of the power unit
2.2.6. Hermetic removal
2.2.7. Removal and installation of the power unit
2.2.8. Check of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.9. Removal and installation of the executive mechanism of change of phases of a gazoraspredeleniye (L3)
2.2.10. Chain of a drive of the mechanism of a gazoraspredeleniye
2.2.11. Removal and installation of the operating oil valve (OCV) (L3)
2.2.12. Check of the operating oil valve (OCV) (L3)
2.2.13. Check of operation of the zolotnikovy valve (OCV) (L3)
2.2.14. The general repair operations on the power unit
2.2.15. Check of a head of the block of cylinders
2.2.16. Assembly of the block of cylinders (beginning)
2.2.17. Assembly of the block of cylinders (termination)
2.2.17.1. Installation of a leading disk (model with an automatic transmission), a flywheel (model with a mechanical transmission)
2.2.17.2. Installation of the oil pallet
2.2.18. Assembly of a head of the block of cylinders
2.2.19. Assembly of a drive of the mechanism of a gazoraspredeleniye
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-2-17-1-ustanovka-vedushhego-diska-modeli-s-avtomaticheskojj-korobkojj-peredach.html

2.2.17.1. Installation of a leading disk (model with an automatic transmission), a flywheel (model with a mechanical transmission)

Hold a cranked shaft from a provorachivaniye by means of the special adaptation.
Fig. 2.180. Order of a tightening of bolts of fastening of a flywheel or leading disk

Tighten fastening bolts in an order specified in drawing 2.180 for some receptions.
Other components establish as it should be, the return to removal and dismantling of the block of cylinders.
«previous page
2.2.17. Assembly of the block of cylinders (termination)		 following page»
2.2.17.2. Installation of the oil pallet