Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.1.1. General information
3.1.2. Check and adjustment of a pedal of coupling
3.1.2.1. Adjustment of height of provision of a pedal
3.1.2.2. Check and adjustment of a free wheeling of a pedal of coupling
3.1.2.3. Verification of the provision of switching off of coupling
3.1.2.4. Removal and installation of a pedal of coupling
3.1.2.5. Removal and installation of tubes of a hydraulic actuator of coupling
3.1.2.6. Removal and installation of the main cylinder of a drive of switching off of coupling
3.1.2.7. Removal, check and coupling installation
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







3-1-2-6-snyatie-i-ustanovka-glavnogo-cilindra-privoda-vyklyucheniya-scepleniya.html

3.1.2.6. Removal and installation of the main cylinder of a drive of switching off of coupling

Merge liquid from a coupling hydraulic actuator.
Remove the main brake cylinder, having turned off fastening bolts.
Remove the vacuum amplifier of brakes, having turned off fastening bolts.
Having weakened a clip, disconnect a tube of a tank of the main cylinder of coupling from the main cylinder of coupling.
Merge liquid in the plastic container.
Disconnect a flexible hose from the main cylinder of coupling.
Using the special adaptation, connect a flexible hose and tighten a fastening nut.

Fig. 3.10. Components of the main cylinder of a drive of switching off of coupling: 1–collar; 2–tube of a hydraulic actuator of switching off of coupling; 3–nut; 4–main cylinder of a drive of switching off of coupling; 5–laying


Connect a tube of a tank of the main cylinder of coupling with a clip to the main cylinder of coupling.

ATTENTION
Connect a tube of a tank of the main cylinder of coupling so that it was not bent.

Establish the vacuum amplifier of brakes.
Establish the main brake cylinder.
Remove air from the main cylinder.
Remove air from brake system.
Having filled a tank of the main brake cylinder with liquid for coupling, remove air from coupling system.
Check and adjust height of a pedal of a brake.
Check and adjust a coupling pedal assembled.
Check leakage of brake liquid.
Check leakage of liquid for coupling.
Check liquid level in a tank of a hydraulic actuator of coupling.

«previous page
3.1.2.5. Removal and installation of tubes of a hydraulic actuator of coupling
following page»
3.1.2.7. Removal, check and coupling installation