3.4.8.1. Removal

Fig. 3.146. Removal of a collar of a cover (from a wheel) special flat-nose pliers

Remove a cover collar (from a wheel) special flat-nose pliers, as shown drawing 3.146.

Unbend a screw-driver blocking clips of a collar.

Fig. 3.147. Removal of a collar of a cover (from a transmission)

Extend the collar end (fig. 3.147).

Fig. 3.148. Marking drawing on the case of the hinge and a power shaft

Mark the case of the hinge and a shaft for the subsequent assembly (fig. 3.148).

Remove the hinge case.

Fig. 3.149. Marking drawing on a power shaft and трипод

Mark a shaft and трипод for the subsequent assembly (fig. 3.149).

Remove a lock ring, using pincers for removal and installation of lock rings.

Remove tripodny connection from a shaft.

ATTENTION Do not strike blows on триподу with a hammer.

NOTE The cover from a wheel should not act in film, except for cases of replacement of a cover, a shaft or the spherical hinge. Do not remove a tape while the cover is not accurate.

Fig. 3.150. Protection шлицов power shaft

Wrap up shlitsa of a shaft a sticky tape (fig. 3.150).

Remove a cover.

NOTE Do not remove a rotor of the sensor of anti-blocking system of brakes (cars with anti-blocking system of brakes) if it is not required. Do not use repeatedly removed rotor of the sensor.

Fig. 3.151. Removal of a rotor of the sensor of anti-blocking system of brakes from a power shaft

Bring down a rotor of the sensor of anti-blocking system of brakes from a power shaft a chisel (fig. 3.151).

Remove a dynamic damper.