|
3-4-4-2-snyatie-i-ustanovka-stupicy-zadnego-kolesa.html
3.4.4.2. Removal and installation of a nave of a back wheel
|
|
Fig. 3.119. Knocking-out of a fillet of a lock-nut of a nave of a wheel
|
Beat out the bent part of a lock-nut outside a small chisel and a hammer (fig. 3.119). Block a nave, having pressed a brake.
Unscrew a lock-nut.
|
ATTENTION
The rotor of the sensor of anti-blocking system of brakes acts in film only in case of its replacement.
|
By means of a chisel remove an ABS sensor rotor (fig. 3.120).
|
|
Fig. 3.121. Correct installation of a rotor of the ABS sensor: 1–wheel nave; 2–ABS sensor rotor
|
To establish an ABS sensor rotor соориентируйте the special adaptation so that marking In was turned down (fig. 3.121).
|
|
Fig. 3.122. Press fitting of a rotor of the ABS sensor
|
Press a new rotor of the sensor with use of the special adaptation and a press (fig. 3.122).
Establish a new lock-nut and stop it, as is shown in drawing 3.123.
|