Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.3.1. General information
3.3.2. Design and operation of the mechanism of transmission
3.3.3. System of electronic control (RSM)
3.3.4. Mechanism of switching of an automatic transmission
3.3.4.1. Principle of operation of the mechanism of switching of an automatic transmission
3.3.4.2. Check of blocking of switching
3.3.4.3. Check of blocking of the ignition key
3.3.4.4. Check of a cable of blocking
3.3.4.5. Check of the lever of the selector
3.3.4.6. Adjustment of a cable of a choice of transfer
3.3.4.7. Adjustment of the switch of a range of a transmission
3.3.4.8. Removal and installation of the lever of the selector
3.3.4.9. Installation of a cable of blocking
3.4. Driving mechanism
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







3-3-4-9-ustanovka-trosa-blokirovki.html

3.3.4.9. Installation of a cable of blocking

Be convinced of that the lever of the selector is in situation P and the ignition key is in the situation LOCK.
Press the mechanism of blocking and rest it against an arm of the limiter of a pedal of a brake.

Fig. 3.94. Fixing of a hook of the mechanism of blocking in an arm opening


From this situation move the blocking mechanism reliably to fix a hook of the mechanism of blocking in an arm opening, as is shown in drawing drawing 3.94.

ATTENTION
The excess or twisting of a cable of blocking at installation can negatively affect operation of the mechanism of blocking.


Fig. 3.95. Installation of a tip of a cable of blocking on a cam pin


Establish a tip of a cable of blocking on a cam pin on the selector lever (fig. 3.95).

Fig. 3.96. Laying of a cable of blocking in a groove of a basic plate of the lever of the selector


Lay a blocking cable in an U-shaped groove of a basic plate of the lever of the selector and establish a clip (fig. 3.96).

ATTENTION
The annex of effort to a blocking cable at installation of a clamp can negatively affect operation of the mechanism of blocking.

Press a clamp of a cable of blocking before it will block.

Fig. 3.97. Removal of a pin of the mechanism of blocking


Remove a pin of the mechanism of blocking, as is shown in drawing 3.97.
Turn the ignition key in situation ASS.
Establish a blocking cable on the key cylinder.

Fig. 3.98. Clip installation on a convex part of the external case of the cylinder


Move the external case to the cylinder of a key and establish a clip on a convex part of the external case (fig. 3.98).

«previous page
3.3.4.8. Removal and installation of the lever of the selector
following page»
3.4. Driving mechanism