Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.3.1. General information
3.3.2. Design and operation of the mechanism of transmission
3.3.3. System of electronic control (RSM)
3.3.4. Mechanism of switching of an automatic transmission
3.3.4.1. Principle of operation of the mechanism of switching of an automatic transmission
3.3.4.2. Check of blocking of switching
3.3.4.3. Check of blocking of the ignition key
3.3.4.4. Check of a cable of blocking
3.3.4.5. Check of the lever of the selector
3.3.4.6. Adjustment of a cable of a choice of transfer
3.3.4.7. Adjustment of the switch of a range of a transmission
3.3.4.8. Removal and installation of the lever of the selector
3.3.4.9. Installation of a cable of blocking
3.4. Driving mechanism
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







3-3-4-7-regulirovka-pereklyuchatelya-diapazona-korobki-peredach.html

3.3.4.7. Adjustment of the switch of a range of a transmission

Disconnect a wire from the negative plug of the storage battery.

Fig. 3.82. Detachment of a cable of management of a transmission


Unscrew a nut and disconnect a cable of management of a transmission (fig. 3.82).

Fig. 3.83. Installation of a shaft of the switch of prohibition of start in situation N


Establish a shaft of the switch of prohibition of start in situation N, as is shown in drawing 3.83.

Fig. 3.84. Detachment of the socket of the switch of prohibition of start


Disconnect the socket of the switch of prohibition of start (fig. 3.84).

Fig. 3.85. Bolts of fastening of the switch of prohibition of start


Weaken bolts of fastening of the switch of prohibition of start (fig. 3.85).

Fig. 3.86. Socket of the switch of prohibition of start


Connect an ohmmeter to conclusions In and From the socket of the switch of prohibition of start (fig. 3.86).
Turning the switch of prohibition of start, define situation at which there is a conductivity between socket conclusions.
Nominal indication of value of an ohmmeter: 750 Ohm.
Tighten bolts of fastening of the switch of prohibition of start.
Inhaling moment: 8–11 N · m.
Be convinced that position of the selector corresponds to position of the switch of prohibition of start.
Connect the socket of the switch of prohibition of start.

Fig. 3.87. Installation of a clamp of a cable of management by a transmission


Establish a clamp of a cable of management of a transmission, as is shown in drawing 3.87.
Tighten a nut of fastening of a cable of management of a transmission and adjust its situation.
Establish a clamp and a cable of management of a transmission.
Connect the negative plug of the storage battery.

«previous page
3.3.4.6. Adjustment of a cable of a choice of transfer
following page»
3.3.4.8. Removal and installation of the lever of the selector