4.3.1.1. Removal

Fig. 4.15. Components of a forward amortizatorny rack: 1–bolt (sensor of speed of a wheel of anti-blocking system of brakes); 2–bolt (arm of a brake hose); 3–nut (stabilizer rack); 4–bolt (the lower part of the shock-absorber); 5–dynamic damper; 6–shock-absorber fork; 7–nut (the top part of the shock-absorber); 8–forward shock-absorber and cylindrical spring; 9–nut of a rod of the piston; 10-rubber support; 11-buffer of a course of compression; 12-protective cover; 13-cylindrical spring; 14-forward shock-absorber

Components of a forward amortizatorny rack are shown on fig. 4.15.

ATTENTION Performance of the following procedures without preliminary removal of the sensor of speed of a wheel of anti-blocking system of brakes can lead to chain break in a plait of wires if the plait is by mistake tense. Before performance of the following operations remove the sensor of speed of a wheel of anti-blocking system of brakes (from a nave) and fix it in a suitable place where the sensor will not be by mistake damaged at service performance.

Unscrew a bolt of fastening of the sensor of speed of a wheel.

Unscrew a bolt of fastening of an arm of a brake hose.

Unscrew a nut of fastening of a rack of the stabilizer and a bolt of fastening of the lower part of the shock-absorber.

Remove a dynamic damper.

Turn off a bolt of fastening of a fork of the shock-absorber.

Weaken, but do not turn off finally three nuts of fastening of the top cover of a rack of the shock-absorber.

Remove the shock-absorber in collecting and fix it at the special stand.

Close a spring a fabric and establish special adaptations.

Fig. 4.16. Removal of a nut of fastening of a rod of the shock-absorber

Compress a spring by means of the adaptation and unscrew a nut of fastening of a rod of the shock-absorber (fig. 4.16).