Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Conditioner and heater
8.2.1. Air filter
8.2.2. Block of central air of air
8.2.3. Evaporator
8.2.4. Broad valve
8.2.5. Condenser
8.2.6. Conditioner control system
8.2.7. Control unit climatic installation
8.2.8. Check of a radiator of a heater
8.2.9. Removal and installation of a back air line
8.2.10. Removal and installation of the compressor of central air of air
8.2.11. Dismantling and assembly of the obgonny coupling
8.2.12. Care of a car body
 







8-2-3-isparitel.html

8.2.3. Evaporator

The evaporator of new type in which are incorporated the multiline evaporator (consisting of an element of condensation and an overcooling element) and a gazo-liquid separator (modulator) is used.
The case of the evaporator is covered with polymer which contains antibacterial substance for elimination of a source of an unpleasant smell and distribution of bacteria.
Placement of tanks in the top and lower part of the block of the evaporator, and also an internal design of plates allowed to provide the following:
– efficiency of heat exchange is improved;
– distribution of temperatures became more homogeneous;
– the evaporator became thinner.

Fig. 8.81. Operation of the evaporator


In the accepted cycle of preliminary cooling after the coolant passes through an element of condensation of the evaporator, liquid and gaseous coolants which could not be liquefied, are cooled again in an overcooling element. Thus, the coolant is sent to the evaporator in almost completely liquefied condition (fig. 8.81).

«previous page
8.2.2. Block of central air of air
following page»
8.2.4. Broad valve