Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Conditioner and heater
8.2.1. Air filter
8.2.2. Block of central air of air
8.2.3. Evaporator
8.2.4. Broad valve
8.2.5. Condenser
8.2.6. Conditioner control system
8.2.7. Control unit climatic installation
8.2.8. Check of a radiator of a heater
8.2.9. Removal and installation of a back air line
8.2.10. Removal and installation of the compressor of central air of air
8.2.11. Dismantling and assembly of the obgonny coupling
8.2.12. Care of a car body
 







8-2-10-snyatie-i-ustanovka-kompressora-sistemy-kondicionirovaniya-vozdukha.html

8.2.10. Removal and installation of the compressor of central air of air

Disconnect a negative wire from the storage battery.
Discharge a coolant.
Remove the right mudguard and an antisplash guard.
Weaken a tension of a driving belt and remove a belt.

ATTENTION
At hit of moisture or impurity in a cooling contour cooling ability of a contour decreases and abnormal noise is audible. Always close jams an open fitting after removal of any elements of a contour of cooling for prevention of hit of moisture or impurity in a contour.


Fig. 8.89. Removal of the compressor of the conditioner: 1–cooler hose (top); 2–a cooler No. 4 hose (cars with the left arrangement of a steering); 3–socket of the magnetic coupling; 4–compressor of central air of air


Remove in an order specified in drawing 8.89.
Establish as it should be, the return to removal.
Adjust a tension of a driving belt.
Execute operational tests of central air.

«previous page
8.2.9. Removal and installation of a back air line
following page»
8.2.11. Dismantling and assembly of the obgonny coupling