Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. General information
4.2. Wheels and tires
4.2.1. Adjustment of corners of installation of wheels
4.2.1.1. Preliminary check of adjustment of installation of wheels
4.2.1.2. Adjustment of the maximum angle of rotation of forward wheels
4.2.1.3. Complete adjustment of a convergence of wheels
4.2.1.4. Adjustment of disorder of wheels
4.2.1.5. Complete adjustment of a convergence of wheels
4.2.2. Balancing of wheels (16-inch and 17-inch cast light-alloy wheels)
4.3. Forward suspension bracket
4.4. Back suspension bracket
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 






4-2-1-3-polnaya-regulirovka-skhozhdeniya-koles.html

4.2.1.3. Complete adjustment of a convergence of wheels

Establish a steering wheel directly and be convinced that vehicle wheels too are established directly.
Weaken lock-nuts of the left and right tip of steering draft and turn steering drafts on identical corners. Both helmsmen of draft have the right carving. Turn the right steering bent for of a forward part of the car, left – to a back part for increase in a convergence of wheels.

NOTE
Rotation of both steering drafts on one complete turn changes a convergence of wheels approximately to 6 mm.

Tighten lock-nuts of a tip of steering draft nominal effort of an inhaling.
Inhaling moment: 68,6–98,0 N · m.
Be convinced of that the cover is not overwound, and establish a cover collar.

NOTE
Adjust a convergence of wheels after installation of disorder of wheels.

«previous page
4.2.1.2. Adjustment of the maximum angle of rotation of forward wheels
following page»
4.2.1.4. Adjustment of disorder of wheels