Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.3. Removal and installation of a nave of a forward wheel
3.4.4. Removal and installation of a nave of a back wheel
3.4.5. Removal and installation of a forward connecting shaft
3.4.6. Assembly and dismantling of a connecting shaft
3.4.7. Removal and installation of a power shaft (cars with a mechanical transmission)
3.4.8. Removal and installation of a power shaft (cars with an automatic transmission)
3.4.9. Removal and installation of a power shaft (cars with a mechanical transmission)
3.4.9.1. Removal
3.4.9.2. Installation
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 






3-4-9-1-snyatie.html

3.4.9.1. Removal

Fig. 3.160. Marking drawing on the case of the hinge and a power shaft


Mark the case of the hinge and a shaft for the subsequent assembly (fig. 3.160).

ATTENTION
Put marking by paint; do not use the puncher.

Remove a clip.
Mark a holder and a separator.
Remove a lock ring, using pincers for removal and installation of lock rings.

Fig. 3.161. Separator removal


Turn a separator approximately on 30 ° and separate a separator and balls from a holder (fig. 3.161).

«previous page
3.4.9. Removal and installation of a power shaft (cars with a mechanical transmission)
following page»
3.4.9.2. Installation