3.4.7.2. Removal

Merge transmission oil.

Remove a support of the brake mechanism.

Remove a brake disk.

Remove the spherical hinge of a tip of the helmsman of draft.

Remove a rack of the stabilizer of cross-section stability.

Turn off bolts of fastening and remove the sharovy hinge of the forward bottom lever (a back part).

Remove the sharovy hinge of the forward bottom lever (a forward part).

Fig. 3.140. Installation of a spare nut on a power shaft

Establish a spare nut on a power shaft so that the nut was aflush from the end of a power shaft (fig. 3.140).

Strike on a nut with a copper hammer to weaken landing of a power shaft in a wheel nave.

Separate a power shaft from a wheel nave.

ATTENTION Sharp edges of a power shaft can cut or punch an epiploon. Be careful at separation of a power shaft from a transmission.

Fig. 3.141. Removal of the left power shaft from a transmission by means of a core

Separate the left power shaft from a transmission, using as the lever a core inserted between the hinge and a transmission, as shown in drawing 3.141.

Establish the special adaptation for keeping of semi-axial gear wheels after removal of a connecting shaft in a transmission.