3.4.5.2. Removal

Merge oil from a transmission.

Remove the sensor of anti-blocking system of brakes.

Fig. 3.126. Removal of the spherical hinge of a tip of the helmsman of draft

By means of the special adaptation remove the sharovy hinge of a tip of the helmsman of draft (fig. 3.126).

Fig. 3.127. Removal of the spherical hinge of the bottom back lever

By means of the special adaptation remove the sharovy hinge of the bottom back lever (fig. 3.127).

Fig. 3.128. Removal of a support of the back brake mechanism

Remove a support of the back brake mechanism and suspend it on a wire (fig. 3.128).

ATTENTION Sharp edges of a connecting shaft can cut or punch an epiploon. Be careful at separation of a connecting shaft from a transmission.

Fig. 3.129. Installation of the special adaptation for keeping of a semi-axial gear wheel

Extend a connecting shaft directly.

Establish the special adaptation for keeping of a semi-axial gear wheel after removal of a connecting shaft in a transmission.

Other components remove and establish as it should be, the return to removal.

Fig. 3.130. Installation of a new clip on a connecting shaft

Before installation put on a connecting shaft a new clip a cut up (fig. 3.130).

After installation measure external diameter.

If it exceeds norm, repeat installation with use of a new clip.

Maximum external diameter: 31,2 mm.