Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.2.1. General information
3.2.2. Check and oil replacement in a mechanical transmission
3.2.3. Removal and installation of the sensor of a speedometer of the car (without anti-blocking system of brakes)
3.2.4. Epiploon replacement (differential)
3.2.5. Removal and installation of the mechanism of gear shifting
3.2.5.1. Instructions on installation of a cable of a choice of transfer
3.2.6. Coupling case, dismantling of elements of a case of the main transfer
3.2.7. Check and assembly of components of differential and case of the main transfer
3.3. Automatic transmission
3.4. Driving mechanism
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 




e31569a4

3-2-5-snyatie-i-ustanovka-mekhanizma-pereklyucheniya-peredach.html

3.2.5. Removal and installation of the mechanism of gear shifting





Mechanism of gear shifting of the Mazda 6 car
Fig. 3.29. Mechanism of gear shifting of the Mazda 6 car: 1–gear shifting lever; 2–cover panel; 3–clip; 4–washer; 5–sealing plate; 6–main cable of a drive of switching; 7–main cable of a choice of transfer; 8–block of the lever of gear shifting


Remove the storage battery, its tray and an arm of fastening of a tray.
Remove an element of the air filter.

Dashboard removal
Fig. 3.30. Dashboard removal


Having turned off seven bolts, two screws of fastening and having taken out three percussion caps, remove the dashboard (fig. 3.30).

Removal of the module of management of system of improvement of stability
Fig. 3.31. Removal of the module of management of system of improvement of stability: 1–bolts; 2–power supply and management sockets; 3–module


Turn off three bolts of fastening and remove the module of management of system of improvement of stability (fig. 3.31).

Control unit removal by climatic installation
Fig. 3.32. Control unit removal by climatic installation: 1–conditioner; 2–control unit; 3–power supply and management sockets


Remove the control unit climatic installation (fig. 3.32).

Removal of the bottom air lines
Fig. 3.33. Removal of the bottom air lines: 1–right air line; 2–left air line


Remove the bottom air lines (fig. 3.33).
Remove the lever and a cover of the lever of gear shifting.
Remove cables of a drive of gear shifting.
Remove the block of the lever of gear shifting.
Installation make as it should be, the return to removal.
Establish an element of the air filter.
After installation, be convinced that the lever of gear shifting can smoothly move to any situation.

«previous page
3.2.4. Epiploon replacement (differential)
following page»
3.2.5.1. Instructions on installation of a cable of a choice of transfer