Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.4. Appendix 2
2.5. Appendix 3
2.5.1. Control system
2.5.2. Principle of work and purpose of some components of a control system
2.5.3. Codes of malfunctions
2.5.3.1. Codes of malfunctions
2.5.3.2. Synchronization of provision of a cam-shaft
2.5.3.3. Heater of the sensor of concentration of oxygen
2.5.3.4. The pressure sensor in an inlet collector
2.5.3.5. The pressure sensor in an inlet collector
2.5.3.6. The air temperature sensor on an admission (air temperature on an admission)
2.5.3.7. Sensor of provision of a butterfly valve
2.5.3.8. Fuel system
2.5.3.9. Monitoring of the admission of ignition
2.5.3.10. Detonation sensor
2.5.3.11. The valve of a retsirkulyatsiya of the fulfilled gases
2.5.3.12. Neutralization system
2.5.3.13. Electromagnetic valve of a purge
2.5.3.14. Control system of fans of system of cooling
2.5.3.15. Neutral switch
2.5.3.16. The electromagnetic valve of system of an admission with variable characteristics (VAD)
2.5.3.17. PCM block
2.5.3.18. Control system of air hashing
2.5.3.19. Sensor of barometric pressure
2.5.3.20. Generator
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 

2-5-3-1-kody-neispravnostejj.html

2.5.3.1. Codes of malfunctions

Parcel of results of tests of system of continuous monitoring (incomplete code) (mode 07)

1 type of a rideable cycle
If malfunctions are found in the first rideable cycle, incomplete codes will be written down in memory of PCM, as well as diagnostic codes.
After incomplete codes are written down in memory if the PCM block considers that the system is serviceable at any future rideable cycle, the PCM block erases incomplete codes.

2 type of a rideable cycle
The code of the refused system registers in memory of PCM at the first rideable cycle. If malfunction is not found in the second rideable cycle, the PCM block considers that the system came back to a normal state or information on malfunction was erroneous, and erases an incomplete code. If malfunction also is found in the second rideable cycle, the PCM block considers that the system refused and writes down incomplete and diagnostic codes.
After incomplete codes are written down in memory if the PCM block considers that the system is serviceable at any future rideable cycle, the PCM block erases incomplete codes.
«previous page
2.5.3. Codes of malfunctions		 following page»
2.5.3.2. Synchronization of provision of a cam-shaft