1.1.8.1. Indication of indications of time

The display shows the current time if the switch of ignition is in the situation "ON" (ignition is included) or "ASS" (auxiliary consumers of the electric power). If on the display data of the route computer are deduced, press the CLOCK button (hours) to switch the display in a mode of indication of the current time.

NOTE On the cars equipped with the route computer, at installation of indications of hours it is necessary to use the INFO button (information) instead of the SET button (installation).

Press and hold the CLOCK button (hours), the short sound signal yet will not be distributed. On the display the 12nr or 24nr indicator, corresponding to 12 and a 24-hour mode of indication of time will light up.

Press the SET button to switch to 12 and 24-hour modes of indication of time. Thus the indicator of the chosen mode will start to blink.

To choose a demanded mode of indication of time, press the CLOCK button (hours) once again while the indicator of the chosen mode continues to blink.

Then on the display the indicator «Hr will light up. ADJUST» (installation of the current time – hours), and two left categories (hours) will start to blink. By means of the SET button establish demanded indications of the current time in two left categories (hours) and then press the CLOCK button (hours).

Then on the display the indicator «Min will light up. ADJUST» (installation of the current time – minutes), and two right categories (minute) will start to blink. By means of the SET button establish demanded indications of the current time in two left categories (hours) and then press the CLOCK button (hours).

During indication of the current time press the SET button and hold it not less than one and a half seconds. At an otpuskaniye of the button the short sound signal will be distributed, and indications of hours will change.

12:01–12:29–12:00

12:30–12:59–1:00

NOTE At an otpuskaniye of the SET button there is a zeroing of categories of seconds.