Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. Conditioner and heater
8.2.1. Air filter
8.2.2. Block of central air of air
8.2.3. Evaporator
8.2.4. Broad valve
8.2.5. Condenser
8.2.6. Conditioner control system
8.2.7. Control unit climatic installation
8.2.8. Check of a radiator of a heater
8.2.9. Removal and installation of a back air line
8.2.10. Removal and installation of the compressor of central air of air
8.2.11. Dismantling and assembly of the obgonny coupling
8.2.11.1. Removal of a bolt of the obgonny coupling
8.2.11.2. Adjustment of the obgonny coupling
8.2.11.3. Check of the obgonny coupling
8.2.12. Care of a car body
 







8-2-11-2-regulirovka-obgonnojj-mufty.html

8.2.11.2. Adjustment of the obgonny coupling

Fig. 8.94. Gap measurement on a circle between a press disk and a compressor pulley


Measure a gap on a circle between a press disk and a pulley of the compressor of central air of air, using a tolshchinomer (fig. 8.94).
Be convinced of that the gap corresponds to norm.

Fig. 8.95. Installation of new laying between a press disk and a compressor pulley


If it not so, remove press a disk and adjust a gap selection of laying of 0,2-0,5 mm or several laying (fig. 8.95).

«previous page
8.2.11.1. Removal of a bolt of the obgonny coupling
following page»
8.2.11.3. Check of the obgonny coupling