Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.1.1. A car design with a body "sedan"
8.1.2. A car design with a body "hatch-back"
8.1.3. Body framework
8.1.4. Hinged and decorative components of a body
8.1.5. Doors
8.1.6. Window regulators
8.1.7. Dismantling and trunk lid assembly
8.1.8. Removal and installation of a front bumper
8.1.9. Dismantling and assembly of a front bumper
8.1.10. Removal and installation of a rear bumper
8.1.11. Removal and installation of a back slip
8.1.12. Removal and installation of a back spoiler
8.1.13. External rear-view mirrors
8.1.14. Removal and installation of an external mirror with the electric drive
8.1.15. Dismantling and assembly of an external mirror with the electric drive
8.1.16. Heater of back glass
8.1.17. The hatch on a roof
8.1.17.1. Removal and installation of the deflector of the hatch
8.1.17.2. Removal and installation of glass of the hatch
8.1.17.3. Hatch adjustment
8.1.18. Seat belts
8.1.19. Seats
8.2. Conditioner and heater
 







8-1-17-3-regulirovka-lyuka.html

8.1.17.3. Hatch adjustment

Completely close hatch glass.

Fig. 8.60. Gap measurement between glass of the hatch and a body


Measure a gap and height between the glass panel and a body (fig. 8.60).
If the height does not correspond to norm, weaken screws of the panel and again establish glass.
Gap:
a–0,8–1,2 mm;
b–0 mm.
Tighten screws.

Fig. 8.61. Check of density of closing of the hatch


Insert the card between a sealant and a car body. Be convinced that the hatch is densely closed (when moving the card resistance) (fig. 8.61) is felt.
If the hatch is not closed densely, again modify its situation.

«previous page
8.1.17.2. Removal and installation of glass of the hatch
following page»
8.1.18. Seat belts