Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of brake system
6.2.2. Check of level of brake liquid in a tank of a hydraulic actuator of working brake system
6.2.3. Brake hoses
6.2.4. Air removal from brake system
6.2.5. Check of the return valve of a vacuum hose (amplifier of brakes)
6.2.6. Check of a pedal of a brake
6.2.7. Removal and installation of a pedal of a brake
6.2.8. Removal and installation of the main brake cylinder
6.2.9. Check of the sensor of level of liquid
6.2.10. Dismantling and assembly of the main cylinder
6.2.11. Removal and installation of a forward brake disk
6.2.12. Replacement of forward brake shoes
6.2.13. Check of lay brake system
6.2.14. Removal, check and installation of the back sensor of speed of a wheel of ABS
7. Onboard electric equipment
8. Body
 







6-2-3-tormoznye-shlangi.html

6.2.3. Brake hoses

It is necessary to check hoses of brake system, at least, two times a year.
For the prevention of sudden refusal of brake system carefully check a condition of all pipelines and connections, paying special attention to the following:
1. Metal pipelines should not have scratches and the centers of corrosion and are located far from sharp edges which can damage them.
2. The brake hose should be elastic, not have anguishes and cracks and is closed strongly up in tips. The carving of tips of a hose should not have damages. If by pressing a brake pedal the hose is inflated, means threads of cords are torn. At detection of any of these defects it is necessary to replace a hose. On hoses mineral oils and the greasings dissolving rubber should not get.
3. All brackets of fastening of pipelines should be whole and are well fixed. Weakening of fastening or destruction of brackets leads to vibration of pipelines which causes their breakages.
4. Leakage of brake liquid from connections of the main cylinder with pipelines and a tank is not allowed.
At detection of malfunctions replace the damaged details new. Flexible hoses, irrespective of their condition, replace new after 120 thousand km of run or after five years of operation of the car to warn sudden gaps because of rubber aging. The brake hose rubbing against a detail of a suspension bracket, wears out and finally fails.
For check use a mirror and illumination.

«previous page
6.2.2. Check of level of brake liquid in a tank of a hydraulic actuator of working brake system
following page»
6.2.4. Air removal from brake system