Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.2. Brake system
6.2.1. Check and adjustment of elements of brake system
6.2.2. Check of level of brake liquid in a tank of a hydraulic actuator of working brake system
6.2.3. Brake hoses
6.2.4. Air removal from brake system
6.2.5. Check of the return valve of a vacuum hose (amplifier of brakes)
6.2.6. Check of a pedal of a brake
6.2.7. Removal and installation of a pedal of a brake
6.2.8. Removal and installation of the main brake cylinder
6.2.9. Check of the sensor of level of liquid
6.2.10. Dismantling and assembly of the main cylinder
6.2.10.1. Dismantling
6.2.10.2. Assembly
6.2.11. Removal and installation of a forward brake disk
6.2.12. Replacement of forward brake shoes
6.2.13. Check of lay brake system
6.2.14. Removal, check and installation of the back sensor of speed of a wheel of ABS
7. Onboard electric equipment
8. Body
 







6-2-10-1-razborka.html

6.2.10.1. Dismantling

Uncover and take the mesh filter from a tank of the main brake cylinder.
Turn off the screw of fastening and remove a tank.
Remove two sealing rings.
Establish the cylinder in a vice.
Using a screw-driver, push pistons on all course, unscrew a lock bolt and remove ring consolidation.

NOTE
Wind a screw-driver with a plaster or a sticky tape not to damage pistons and a cylinder mirror.

Fig. 6.29. Removal of a spring ring


Press the piston a screw-driver and by means of tonkogubets for removal of spring rings remove a spring ring (fig. 6.29).


Fig. 6.30. Extraction of the primary piston with a spring


Turn off a lock piston bolt with laying and take the primary piston with a spring, extending it it is strict on an axis without distortions (fig. 6.30).

NOTE
If the piston to take at an angle, it is possible to damage a cylinder mirror.


Fig. 6.31. Extraction of the secondary piston


Put a rag on two wooden whetstones and easily strike with a cylinder flange on whetstones while the secondary piston will not come to light. Be convinced that distance (And), specified in drawing 6.31, from a rag to top of whetstones – not less than 100 mm.
Be convinced of lack of a rust and scratches on a cylinder mirror.
Be convinced of lack of wear and cylinder damages.
If it is necessary, replace the cylinder.

ATTENTION
Replace all details, in the repair kit, used for service of the main brake cylinder.
At installation grease rubber details with pure brake liquid for simplification of assembly. Do not use the production compressed air for drying and cleaning of details of the brake mechanism. It can damage rubber details. If any detail of hydraulic system is removed or disconnected, completely pump over brake system.
Perform all repair work on a pure workbench.


«previous page
6.2.10. Dismantling and assembly of the main cylinder
following page»
6.2.10.2. Assembly