3.4.7.3. Installation

Fig. 3.142. Installation of the special adaptation for keeping of semi-axial gear wheels

Fig. 3.143. Installation on a connecting shaft of a new clip

Establish on a connecting shaft a new clip a cut up. Be convinced that diameter of a clip does not exceed norm (fig. 3.143).

After installation, measure external diameter.

If it differs from norm, repeat installation with use of a new clip.

Maximum external diameter: 31,2 mm.

Insert a power shaft into a wheel nave.

Fig. 3.144. Installation of a power shaft

Put transmission oil on a working edge of an epiploon (fig. 3.144).

Insert a power shaft into a transmission.

After installation pull the case of the internal hinge on itself to be convinced of reliability of fixing of a power shaft.

Installation of other components make as it should be, the return to removal.