Mazda 6 since 2002
	1. Operation and car maintenance
	2. Engine
		2.1. General description of new engines of the L8, LF and L3 models
		2.2. Mechanical part of engines
		2.3. Appendix 1
		2.4. Appendix 2
		2.5. Appendix 3
			2.5.1. Control system
			2.5.2. Principle of work and purpose of some components of a control system
			2.5.3. Codes of malfunctions
				2.5.3.1. Codes of malfunctions
				2.5.3.2. Synchronization of provision of a cam-shaft
				2.5.3.3. Heater of the sensor of concentration of oxygen
				2.5.3.4. The pressure sensor in an inlet collector
				2.5.3.5. The pressure sensor in an inlet collector
				2.5.3.6. The air temperature sensor on an admission (air temperature on an admission)
				2.5.3.7. Sensor of provision of a butterfly valve
				2.5.3.8. Fuel system
				2.5.3.9. Monitoring of the admission of ignition
				2.5.3.10. Detonation sensor
				2.5.3.11. The valve of a retsirkulyatsiya of the fulfilled gases
				2.5.3.12. Neutralization system
				2.5.3.13. Electromagnetic valve of a purge
				2.5.3.14. Control system of fans of system of cooling
				2.5.3.15. Neutral switch
				2.5.3.16. The electromagnetic valve of system of an admission with variable characteristics (VAD)
				2.5.3.17. PCM block
				2.5.3.18. Control system of air hashing
				2.5.3.19. Sensor of barometric pressure
				2.5.3.20. Generator
	3. Transmission
	4. Running gear
	5. Steering mechanism
	6. Brake system
	7. Onboard electric equipment
	8. Body

2-5-3-9-monitoring-propuska-zazhiganiya.html

2.5.3.9. Monitoring of the admission of ignition

The casual admission of ignition (P0300) is found, the ignition admission in the cylinder (by P0301, P0302, P0303, P0304) is found

The PCM block supervises a time interval of an entrance signal of the sensor of position of the crankshaft. The PCM block calculates change of a time interval for each cylinder. If change of a time interval exceeds previously the programmed values, the PCM block finds the ignition admission in the corresponding cylinder. In engine operating time the PCM block considers number of admissions of ignition which occurred for each 200 and 1000 turns of a cranked shaft, and calculates factor of the admission of ignition for each turn of a cranked shaft. If the relation exceeds previously the programmed values, the PCM block decides that there was an admission of ignition which can lead to damage of catalytic converter or influence characteristics of emissions.

«previous page
2.5.3.8. Fuel system

following page»
2.5.3.10. Detonation sensor