1.2.1.10. Signaling device of malfunction of system of safety cushions and prednatyazhitel of seat belts

If system of safety cushions and prednatyazhitel of seat belts on forward seats are in good repair, the signaling device of malfunction should light up at turn of the switch of ignition in the situation "ON" (ignition is included) or at starter inclusion. Then, after a while, the signaling device should go out.

If the signaling device burns constantly or does not join at all at turn of the switch of ignition in the situation "ON" (ignition is included), it testifies to malfunction of system of safety cushions or prednatyazhitel of seat belts. In this case urgently, as soon as possible, address on service station of the official dealer of Mazda. If the signaling device indicates malfunction, safety cushions or prednatyazhitel of belts can not work at a road accident.

If malfunction of system of pillows of safety / преднатяжителей seat belts is found and the malfunction signaling device burns, the sound alarm system of malfunction at the same time starts to function. The sound signal by duration will be distributed about five seconds every minute.

The sound alarm system of malfunction of system of pillows of safety / преднатяжителей seat belts will work approximately within 35 minutes.

Fig. 1.136. Table of inclusion of visual and sound signaling devices of a driver's seat

Visual and sound signaling devices in addition remind the driver of need to fasten a seat belt. If a seat belt of the driver will not fasten, when the switch of ignition is in the situation "ON" (ignition is included), warning visual and sound signaling devices which function according to the table provided below (fig. 1.136) join.

If the sound signaling device joined, at not fastened seat belt it will continue to work, even if speed of the car will fall below 20 km/h. The signaling device will be switched off, as soon as the seat belt or after the lapse of established time will be fastened.

Visual and sound signaling devices remind the forward passenger of need to fasten a seat belt.

Fig. 1.137. Table of inclusion of visual and sound signaling devices of a forward passenger seat

If a seat belt of the forward passenger will not fasten, when the switch of ignition is in the situation "ON" (ignition is included), warning visual and sound signaling devices which function according to the table provided below (fig. 1.137) join.

If the sound signaling device joined, at not fastened seat belt it will continue to work, even if speed of the car will fall below 20 km/h. The signaling device will be switched off, as soon as the seat belt or after the lapse of established time will be fastened.

Fig. 1.138. Signaling devices of not fastened seat belt of a back seat

If seat belts on back sitting are not fastened and the switch of ignition is in the situation "ON" (ignition is included), the driver and passengers will receive the prevention of it by means of visual and sound signaling devices. The visual signaling device lights up over a rear-view mirror (fig. 1.138).

The signaling device can burn with red or green light. If a seat belt will not fasten, the red signaling device burns. If a seat belt will fasten, the signaling device burns with green light. Visual signaling devices work, even if on back sitting passengers are absent. The sound signaling device joins, only if to unfasten the fastened seat belt.

NOTE If seat belts on back sitting are not fastened during established time after engine start, all visual signaling devices will be switched off.