Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. General information
3.4.2. Forward power shafts
3.4.3. Removal and installation of a nave of a forward wheel
3.4.3.1. Removal
3.4.3.2. Installation
3.4.4. Removal and installation of a nave of a back wheel
3.4.5. Removal and installation of a forward connecting shaft
3.4.6. Assembly and dismantling of a connecting shaft
3.4.7. Removal and installation of a power shaft (cars with a mechanical transmission)
3.4.8. Removal and installation of a power shaft (cars with an automatic transmission)
3.4.9. Removal and installation of a power shaft (cars with a mechanical transmission)
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







3-4-3-1-snyatie.html

3.4.3.1. Removal

Fig. 3.103. Knocking-out of a fillet of a lock-nut of a nave of a wheel


Beat out the bent part of a lock-nut outside a small chisel and a hammer (fig. 3.103).
Block a nave having pressed a brake.
Unscrew a lock-nut.

Fig. 3.104. Removal of a nave of a wheel from a drive shaft


Place a nave assembled in a vice. Remove a wheel nave from a drive shaft, using special adaptations (fig. 3.104).
If the internal ring of the bearing remained on an axis of a nave of a wheel, cut through an internal ring of the bearing till residual thickness, (about 0,5 mm).

Fig. 3.105. Removal of an internal ring of the bearing


After that remove a ring a chisel (fig. 3.105).

Fig. 3.106. Removal of the bearing of a nave


Remove the bearing of a nave of a wheel, using special adaptations (rice 3.106).

Fig. 3.107. Marking of a casing of a nave and rotary fist


Mark a protective casing and a rotary fist for further installation (fig. 3.107).

Fig. 3.108. Removal of a protective casing of a nave


By means of a chisel remove a protective casing (fig. 3.108).

Fig. 3.109. Removal of bolts of a nave


Establish a nave in a press and remove bolts (fig. 3.109).

NOTE
Bolts of a nave should be removed only in case of their replacement.

«previous page
3.4.3. Removal and installation of a nave of a forward wheel
following page»
3.4.3.2. Installation