3.2.7.2. Assembly of a cylindrical pin

Fig. 3.53. Installation of a new cylindrical pin

Establish a new cylindrical pin, as is shown in drawing 3.53 to hold an axis of satellites.

Measure a gap according to the following procedure.

Establish the left and right power shafts in differential.

Support power shafts prisms.

Fig. 3.54. Measurement of a gap of satellites

Measure a gap of both satellites (fig. 3.54).

Gap: 0,050–0,150 mm.

If results of measurements differ from norm, replace the worn-out and damaged details.