Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
2.1. General description of new engines of the L8, LF and L3 models
2.2. Mechanical part of engines
2.3. Appendix 1
2.3.1. Greasing system
2.3.1.1. Check of pressure of oil
2.3.1.2. Replacement of engine oil
2.3.1.3. Replacement of the oil filter
2.3.1.4. Removal and installation of a maslookhladitel
2.3.1.5. Removal and installation of the oil pallet
2.3.1.6. Removal and installation of the oil pump
2.3.2. Cooling system
2.3.3. Fuel system
2.3.4. Release system
2.4. Appendix 2
2.5. Appendix 3
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







2-3-1-5-snyatie-i-ustanovka-maslyanogo-poddona.html

2.3.1.5. Removal and installation of the oil pallet

Stop the engine and wait, while the engine and engine oil will not cool down.
Disconnect a negative wire of the storage battery.
Remove the bottom protective cover.
Merge engine oil.
Remove a forward cover of the engine.

Fig. 2.205. Removal of the oil pallet: 1–masloizmeritelny щуп; 2–oil pallet


Lift the receiver masloizmeritelny щупа and the oil pallet (fig. 2.205).

Fig. 2.206. Alignment of the oil pallet on the block of cylinders


Use a corner to level the oil pallet on the block of cylinders from a forward cover of the engine (fig. 2.206).

Fig. 2.207. Hermetic drawing before installation of the oil pallet


Put kremniyevoorganichesky hermetic on an interfaced surface of the oil pallet, as is shown in drawing 2.207.

Fig. 2.208. Order of a tightening of bolts of fastening of the oil pallet


Tighten bolts of fastening of the pallet in an order specified in drawing 2.208.
Check oil level.
Start the engine and check absence of leakage of oil. In the presence of leak define a defective detail, repair or replace it.

«previous page
2.3.1.4. Removal and installation of a maslookhladitel
following page»
2.3.1.6. Removal and installation of the oil pump