Mazda 6 since 2002
1. Operation and car maintenance
1.1. Car description
1.2. System of passive safety
1.3. Car use to destination
1.3.1. Engine start-up
1.3.2. Management of a mechanical transmission
1.3.3. Management of an automatic transmission
1.3.4. System of course stability of the car (cruise control)
1.3.5. Protivobuksovochny system (TCS)
1.3.6. Protivozanosny system (DSC)
1.3.7. Stabilization of a back suspension bracket
1.3.8. Traction coupling device
1.4. Elimination of the malfunctions which have arisen in a way or before a start of motion
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







1-3-2-upravlenie-mekhanicheskojj-korobkojj-peredach.html

1.3.2. Management of a mechanical transmission

Fig. 1.156. Gear shifting scheme


On the car the usual scheme of gear shifting, as is shown in drawing (for 5 and 6-step transmissions) (fig. 1.156) is used.
At gear shifting completely press a coupling pedal. After transfer inclusion smoothly release a coupling pedal.
5-step transmission.
The safety device excludes casual inclusion of transfer of a backing of "R" from the situation "5" corresponding to the fifth transfer. To include transfer of a backing of "R", at first it is necessary to transfer the lever to neutral situation.
6-step transmission.
Cars with a 6-step transmission are equipped with the device preventing erroneous inclusion of transfer of a backing. Press the gear shifting lever vertically down and then transfer it to the situation "R".

ATTENTION
Do not hold constantly a foot on a coupling pedal. Press a coupling pedal only at gear shifting. It is forbidden to hold the car from a skatyvaniye down on lifting at the expense of coupling slipping. Long or intensive slipping of coupling will result in premature wear of details and a coupling exit out of operation. Be convinced that the car is motionless before including backing transfer. Inclusion of transfer of a backing under way the car can lead to transmission breakage.

NOTE
If transfer of a backing joins hardly, return the gear shifting lever to neutral situation and release a coupling pedal. Then try to include backing transfer once again.

«previous page
1.3.1.3. Switching off of operation of the engine by means of an auxiliary key
following page»
1.3.3. Management of an automatic transmission