Mazda 6 since 2002
1. Operation and car maintenance
1.1. Car description
1.1.1. Dimensions and general view of the car
1.1.2. Technical characteristics
1.1.3. Identification data of the car
1.1.4. Podkapotnoye space
1.1.5. Refueling capacities of units and the systems, recommended operational materials
1.1.6. Keys, locks of doors, hatch, anticreeping system
1.1.7. Governing bodies and combination of devices
1.1.8. Information display
1.1.9. Electronic immobilizer (anticreeping system)
1.1.9.1. Security alarm system (the additional equipment)
1.1.9.2. Conditions of operation of the sound alarm system (an independent siren)
1.1.9.3. Turning on of the alarm system in a protection mode
1.1.9.4. Shutdown of the sensor of penetration into the car
1.1.9.5. Removal of the alarm system from a protection mode
1.1.9.6. Alarm signal switching off
1.1.9.7. Existence marking on the car of the security alarm system
1.1.10. Heater, conditioner and system of ventilation of salon of the car
1.1.11. Lever of a drive of lay brake system
1.1.12. Seats
1.2. System of passive safety
1.3. Car use to destination
1.4. Elimination of the malfunctions which have arisen in a way or before a start of motion
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
 







1-1-9-4-otklyuchenie-datchika-proniknoveniya-v-avtomobil.html

1.1.9.4. Shutdown of the sensor of penetration into the car

In the cases listed below it is necessary, having turned on the security alarm system, to disconnect the penetration sensor (it will exclude unjustified operations of the security alarm system):
– in the car there was a mobile object;
– in the car there was a subject which can be rolled on salon at a car list (for example when the car is established on the ferry deck);
– near the car metal objects, for example, a portal of the automatic jet washer move.
To disconnect the penetration sensor, press the button of shutdown of the sensor, located on a remote control, not later 20 with after the locking button was pressed.
Thus lamps of indexes of turn will blink three times.
Again to turn on the penetration sensor, remove the alarm system from a mode of protection on duty and then again turn on the alarm system. The sensor of penetration is activated at each turning on of the security alarm system in a mode on duty. In order that the sensor of penetration did not work, it is necessary at each turning on of the alarm system in a mode of protection to press the button of shutdown of the sensor on a remote control.

«previous page
1.1.9.3. Turning on of the alarm system in a protection mode
following page»
1.1.9.5. Removal of the alarm system from a protection mode