Mazda 6 since 2002
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
5.1. General information
5.2. General checks
5.3. Working operations with the steering mechanism
5.4. Removal and installation of the pump of the hydraulic booster
5.4.1. Assembly of components of the pump of the hydraulic booster
6. Brake system
7. Onboard electric equipment
8. Body
 






5-4-1-sborka-komponentov-nasosa-gidrousilitelya.html

5.4.1. Assembly of components of the pump of the hydraulic booster

Installation of a clip of the pump of the hydraulic booster
Fig. 5.34. Installation of a clip of the pump of the hydraulic booster


Put on a clip in the direction shown in drawing 5.34.
Be convinced that the ear of a clip is fixed.

Epiploon installation in the forward case of the pump
Fig. 5.35. Epiploon installation in the forward case of the pump


Establish an epiploon in the forward case of the pump, using the special adaptation and a kapron hammer (fig. 5.35).

Assembly of blades
Fig. 5.36. Assembly of blades


Place blades in a rotor so that the rounded edges were included into a cam (fig. 5.36).

Installation of a statorny ring in the forward case of the pump
Fig. 5.37. Installation of a statorny ring in the forward case of the pump


Establish a statorny ring in the forward case of the pump a label up (fig. 5.37).
After installation of the back case manually turn a shaft to check smoothness of rotation.
Establish a shaft in the forward case of the pump.
Establish the pump and tighten three bolts of fastening.
Establish the socket of the sensor of pressure.
Establish a driving belt.
Pump over a hydraulic contour of the steering mechanism.
Check, whether there is no leak and a podtekaniye of working liquid of hydraulic system.
Make check and installation of a steering wheel.

«previous page
5.4. Removal and installation of the pump of the hydraulic booster
following page»
6. Brake system