|
2-3-2-2-zamena-okhlazhdayushhejj-zhidkosti-dvigatelya.html
2.3.2.2. Replacement of cooling liquid of the engine
|
|
Fig. 2.211. Radiator components: 1–broad tank; 2–radiator; 3–hoses; 4–stopper of a jellied mouth of a radiator; 5–drain stopper of a radiator
|
Remove a drain stopper of a radiator. (see fig. 2.211) Merge cooling liquid in the container.
Wash out system of cooling by water.
Wait full liquid plum from system.
Tighten a drain stopper of a radiator.
Fill a tank with cooling liquid to FULL label.
Completely establish a radiator stopper.
Start the engine and leave it to idle before turning on of the fan of system of cooling.
After the engine will heat up, execute the following:
1. Let's to the engine work on 2500 mines-1 within 5 minutes.
2. Let's to the engine work on 3000 mines-1 during 5 with, and then leave it to idle.
3. Repeat the first two actions several times.
4. Let's to the engine work idling within 1 minute.
Stop the engine and let's to it cool down.
Remove a radiator stopper.
Check level of cooling liquid. If level low, add cooling liquid.
Establish a radiator stopper.
Be convinced of absence of leakages of cooling liquid.
If liquid leaks, repair or replace a stopper of a radiator or a radiator.
|